Ahh-Some for Hot Tubs/Jetted Baths - 6oz

The Ahh-Some jet tub cleaning routine

One and two person jetted tub, use 1 teaspoon. A four person jetted tub, use 2 teaspoons.

Step 1: Fill the jetted tub up with warm water about 1-2 inches above the highest jet, facing the jets downward towards the bottom of the tub.

Step 2: Add 1 teaspoon (or two if required, see above) of the Ahh-Some Jetted Tub Bio Cleaner to the water. You can let dissolve for a minute but you really don’t need to.

Step 3: Turn on the jets. You may have more than one jet circuit, and there may be an air vent that needs to be open. 

Step 4: You should let the jets run for 15 minutes, and during this time period you will see a lot of foaming action, similar to a bubble bath. This is normal. As time goes on, the dirt, grime, oils, skins, flaking, will be drawn to the top of the foam and deposited on the tub wall, as depicted on picture below. This picture reflects the ring around the tub when the jets are off.

Step 5: Turn the jets off after the time period, remove about 2 inches of water and clean the ring around the tub of the gunk that has glued itself to it. Refill the 2 inches of water after you have cleaned the ring.

Step 6: Leave the water in the tub, Repeat Steps 2-4, you should now only use 1/2 of a teaspoon of the bio cleaner and see how that does, if you need a bit more scraping action (you will notice what’s going on) just add a pinch more bio cleaner to the water.

Step 7: Drain the tub after the second cleaning and repeat steps 1-6 as needed.

Note: If you need a bit more scraping action (you will notice what’s going on) just add a pinch more bio cleaner to the water.