No products
Prices are tax included
Large Push In
-
Electric
- Ozone
- Circulation Pumps
- Pumps, Motors & Parts
- PCB's Packs and Panels
- Lighting
- Sensors and Switches
- Electrical Sundries
- Speakers and Audio
- Heating
- LX
- Air
- Gear
-
Water
- Divertor Valves
- On/Off Valves
- Slice and Ball Valves
- Thermowells
- Unions
- Manifolds
- Floor Drains
- Suction
- Pipe
- Fittings
- Water Filtration
- Check Valves
- Water Features
- Drain valves
- Water Chlorination
- Pipe Clamps
- Gaskets and O Rings
-
Jets and Bodies
- Diffusers & Jets Pieces
- Water Jets
- Waterway Jet Bodies
- SCS Jet Bodies
- Waterway Jet Tools
- Hand-Held Jets
- Wellis
- CMP Products
- FILTERS
- Cycle Valves
- HotSpring-Caldera
New products
-
Hydroquip Low Flow System with K450 touchpad
The Hydroquip Low Flow System is built on Gecko YE5 circuitry utilising...
-
Sundance 850 2002 - 2004
Sundance 850 3 PUMP NT WITH CIRC/PERMAC (Picture for illustration only...
-
Aqua Flo Maelstrom 3hp two speed
Aqua Flo Maelstrom 3hp two speed 2" suction and discharge, exactly the...
-
-
4" CMP Directional Jet - Stainless and Graphite
4" CMP Directional jet, Stainless steel with a Graphite colour jet piece.
-
Hot-Springs Pillow
The Hot Spring Limelight Collection Pillow / Headrest fits the following...
-
Water Tank 2,000 litres
Collapsible water tank. Essential for hot tub servicing. 2metre...
-
-
Light lens and seal kit
Hotspring large light lens and seal kit. Front face diameter 135mm....
-
Hotspring Heater O ring gasket 2"
Hotspring heater o ring gaskets, sold in pairs. Hotspring part number...
-
-
-
-
-
-
-
Waterlab Chamber
Seamless under-the-spa inline integration No intrusive devices in your...
-
Gecko IN.TOUCH 3+ KIT
IN.TOUCH 3+ Kit includes: 2 communication transmitters: In.touch 3+...
-
Gecko IN.TOUCH-3 KIT
IN.TOUCH 3 Kit includes: 2 communication transmitters: In.touch 3 Spa...
This section contains jets from Pentair American Plastics, now Hydroair International and Balboa Water Group. They are quite large jets with a distinctive rear part. They fit and release into the hot tub by means of a plastic spring located just inside the front face. Once the spring is held open these jets push in and pull out. If the elasticit...
This section contains jets from Pentair American Plastics, now Hydroair International and Balboa Water Group. They are quite large jets with a distinctive rear part. They fit and release into the hot tub by means of a plastic spring located just inside the front face. Once the spring is held open these jets push in and pull out. If the elasticity of the plastic spring wears out, the jet will pop out from water pressure - this is a sure sign that the jet needs replacing.
