New product
Plastic assembly 3/4" x 3/4" x 3/4" fitted with switch Q-12DS
Thread diameter : 1"
Grey probe length : 1-1/4"
If you don't need the plastic assembly, just buy the switch shown below as an accessory.
This product is no longer in stock
Availability date:
Harwil Reed Flow switch common to systems using Gecko and Hydroquip electronics and Laing heaters.
Thread diameter : 1"
Grey probe length : 1-1/4"
Normally found screwed into a clear plastic housing
Supplied with flow switch and the clear plastic housing - you don't need to replace the clear housing when swapping the switch.
Broken Waterway Jets? Replace only the rear...
Spigot fits inside 2 inch pipe fittings and...
Complete assembly including sensors and seals...
2" spiggot x 3/4" barb
Fitted to EVERY balboa M7 heater. Useful as...
Elbow 90° 2 inch spigot x spigot
2" water manifold (SOC x SPG) with x4 3/4"...
Pump seal to fit 2" unions - flat type. Because...
Capacitor for hot tub motors. Specific size for...