View larger

FibreCor Insulation

Condition: New product

Innovative FibreCor insulation fills your spa cabinet completely to fully insulate your spa.

Can be used on Hot-springs spas and ANY other brands where there is space inside the cabinet.

More details

Ask a question (0)

Send to a friend

Send to a friend

FibreCor Insulation

Innovative FibreCor insulation fills your spa cabinet completely to fully insulate your spa.

Can be used on Hot-springs spas and ANY other brands where there is space inside the cabinet.

Recipient :

Name of your friend ^* :

E-mail address of your friend ^* :

^* Required fields

or Cancel
Print

More info

What is it ?

FibreCor is a proprietary type of full cavity insulation. It completely fills the cabinet, but not with sprayed-in foam. Instead, the cabinet is filled with blown-in, wool-like non-hazardous fiber that has four times the density of the polyurethane foam used in most hot tubs. FibreCor is very evenly dispersed inside the spa cabinet, leaving no gaps or thermal voids. FibreCor offers the same insulating value as polyurethane foam. It is an inorganic material that prevents mold and mildew.

FibreCor is a very recent innovation in hot tub insulation and offers several benefits. It is non-toxic, reusable and partially recycled. It is also very easy to remove and replace if service is necessary.

FibreCor Replacement Kit for the following Spas:

Hot Spot Relay, Rhythm, and Tempo (2010 and newer)
Hot Spot TX (2011-2012)
Solana SX and TX (2006-2010)
Solana RX (2006-2009)
Caldera Palatino and Marino (2010 and newer)
Caldera Vanto (2011 and newer)
Caldera Tarino (2013 and newer)

FibreCor is applied at a 2 lb. density level – which is 4-times greater than that 1/2 lb. foam used in most spas – to maximize energy efficiency and lower operating costs.

No links to the petroleum industry. FibreCor has the added benefit of being environmentally friendly. It’s entirely reusable, easily disposable and made from 25% recycled materials.

Mold and Mildew resistant.

No special disposal requirements.

All Hot Spot spas have been certified to the stringent energy efficiency guidelines set by the California Energy Commission (CEC), as well as to the national standard, APSP 14.

What you need to know is that FibreCor is a fibre like wool that has some very smart characteristics. First of all, because of its composition when applied into the spa it gives a very even dispersion of insulation throughout the entire cabinet. Secondly, Fibercor is a loose fiber it can actually fill virtually every void and gap, as well as tough to reach plumbing area or corner. Thirdly, it is even being applied at a denser level then our previous insulation, which results in even lower operating costs. So even dispersion, fills voids and gaps, higher density, means lower operating costs.

Fibrecor has no link to petroleum, which means its a very clean product to use and reuse. Infact its being made from 25% recycled content. Fibercor is also not a product in short supply. It’s mildew and mold resistant. There is no VOC emissions and no special disposal requirement. It’s just a clean smart solution that’s good for the wallet and good for the environment.