New product
Plastic assembly 3/4" x 3/4" x 3/4" fitted with switch Q-12DS
Thread diameter : 1"
Grey probe length : 1-1/4"
If you don't need the plastic assembly, just buy the switch shown below as an accessory.
This product is no longer in stock
Availability date:
Harwil Reed Flow switch common to systems using Gecko and Hydroquip electronics and Laing heaters.
Thread diameter : 1"
Grey probe length : 1-1/4"
Normally found screwed into a clear plastic housing
Supplied with flow switch and the clear plastic housing - you don't need to replace the clear housing when swapping the switch.
2" Heater tailpiece - MOST COMMON
£4.61
Spigot fits inside 2 inch pipe fittings and...
£4.82
Gaskets are always measured by the internal...
£1.30
Broken Waterway Jets? Replace only the rear...
£5.23
C3549-1 and C3550-1 and C3242-1A D1 Spas Bay...
£329.50
Waterway Plastics - Sealed shut off valve. 2"...
£21.90
56frame - 4hp impellor. For use with Executive...
£94.88
Spigot fits into 2 inch pipe to plug the pipe end
£2.91
2" water manifold with 3/4" ribbed barbs
£12.75
2" water manifold (SOC x SPG) with x4 3/4"...
£6.27