Waterway Cluster Storm Diffusers

Rear white plastic part of Waterway Cluster jets known as the diffuser.

The outside diameter of the diffuser is 24mm.

We continue to be the only supplier in Europe offering ALL of the Waterway diffusers and we always have at least x500 of each type in stock. Yes we have hundreds of complete jets in stock and we are happy to help you buy these, but we also offer the most obvious "save money" alternative which is by replacing the only piece that has actually broken on the jet.

VERY Important note :

Waterway Changed the style of this diffuser a couple of years ago and it WILL NOT fit older Cluster Storm jets.

Before you buy look closely at the images of this diffuser and the location of the 2 additional 'lugs' on the main diameter of the diffuser.

If your broken jet and diffuser does not look like these pictures you will need to buy new complete jets which can be found in the Twist and Click 2" section and are called Cluster Storm.

Diffusers are ONLY the rear piece of the jet - NO OTHER parts come with the diffuser. If you are missing other pieces from your jet, you will need to buy a complete jet.

HOW TO FIT DIFFUSERS:

Whilst it looks easy when you compare the new diffuser to the back of the original face and think...MMMmmm - that just snaps on? - by doing so you will invariably break the small piece of rim plastic (rectangular hole) on the new diffuser.

The best method:
Heat some water (boiled) and keep it simmering in a saucepan.
You need to heat just a small amount of the circumference of the new diffuser.
Pop the diffuser (only the first 1-2mm of the plastic) into the water for around 1 second and then immediately offer to the old jet face and then apply very equal downward pressure.
It's best to have the old face already positioned on a tea towel on the kitchen work surface (you get the idea I am sure) - that way it is nice and flat and ready for the downward pressure.
Don't try to hold the jet face in one hand and the diffuser in the other and offer them together that way because you'll unknowingly be applying unequal pressure. You may notice that the new diffuser has bevelled edges around the rectangular holes, to allow the clipping on. We have found that if you apply too much heat to the diffuser (i.e. keeping it in the water for longer than a very quick "in and out"......hence the 1 second) and as it begins to "ride over" the clips on the jet face, it will remain splayed (the plastic is too soft from the heat) and will not snap over correctly OR it will snap over but a very small piece of plastic will remain which seams to want to bend outwards. This doesn't really matter but it might make you feel that the diffuser hasn't gone completely over.

Make sure you have identified how the diffuser locates onto the jet - it will only clip into one position - there are plastic lugs to help you identify the correct location.

One more thing - you will have the actual jet part (the eyeball or the rotating part of the jet) which lives between the diffuser and the face. You can either place/balance this on the jet face on the tea towel or place it into the diffuser after you have warmed it. They generally sit quite happily inside the diffuser without falling out - have a dry run and see the way you feel most comfortable.